Remington Model 31

Source: Wikipedia, the free encyclopedia.
Remington Model 31
Type
Tubular magazine
SightsBead

The Remington Model 31 is a

29, and the John Browning-designed Model 17. It was replaced by the less expensive to manufacture Model 870 in 1950.[2]

History

While the

The model 31L was a lightweight version featuring an aluminum receiver and trigger housing.

During World War II Remington produced a Model 31 riot gun for military use. These were stamped "U.S. Property" on the left side of the receiver and had an approximate serial number range of 51000-63000. Except for a single prototype, no Model 31 trench guns were produced.[4]

Despite being well received, sales still lagged far behind the Winchester. Remington went back to the drawing board and designed the Model 870; this shotgun matched the durability of the Model 12 at a significantly lower cost. Despite the overwhelming success of the 870, many shotgun connoisseurs consider the Model 31 to be the ne plus ultra of pump shotguns with its "ball-bearing" slide action.[5]

The Model 31 was later used as a basis for the Mossberg 500 and related shotguns. The Mossberg is simplified and cheaper to produce. Notable differences are the use of a two-piece bolt with separate locking piece as well as a significantly simplified barrel mounting system. Further, the bolt locks into a barrel extension rather than directly to the receiver.

References

  1. ^ Remington's Magnificent Five – Page Two
  2. ^ "Firearm Model History - Remington Model 31". Archived from the original on 2007-09-28. Retrieved 2007-06-14. Remington history page
  3. ^ Vanderpool, Bill "Bring Enough Gun" American Rifleman October 2013 pp.80-85&115-116
  4. .
  5. ^ Simpson, Lane. "Remington's Magnificent Five", Shooting Times, May 2000