Signaling compression

For

IETF

.

Overview

SigComp specifications describe a compression schema that is located in between the application layer and the transport layer (e.g. between SIP and UDP). It is implemented upon a virtual machine configuration which executes a specific set of commands that are optimized for decompression purposes (namely UDVM, Universal Decompressor Virtual Machine).

One strong point for SigComp is that the bytecode to decode messages can be sent over SigComp itself, so this allows to use any kind of compression schema given that it is expressed as bytecode for the UDVM. Thus any SigComp compatible device may use compression mechanisms that did not exist when it was released without any firmware change. Additionally, some decoders may be already been standardised, so SigComp may recall that code so it is not needed to be sent over the connection. To assure that a message is decodable the only requirement is that the UDVM code is available, so the compression of messages is executed off the virtual machine, and native code can be used.

As an independent system a mechanism to signal the application conversation (e.g. a given SIP session), a compartment mechanism is used, so a given application may have any given number of different, independent conversations, while persisting all the session status (as needed/specified per compression schema and UDVM code).

General architecture

block diagram — Elements that communicate with each other, see the description page for a detailed explanation

Signaling compression

Overview

General architecture

References

Related standards documents