Chrisstanleyite
| Chrisstanleyite | ||
|---|---|---|
| General | ||
| Category | Specific gravity 3.6 | |
| Density | 8.31 | |
| Pleochroism | very light to green-grey buff | |
| References | [2][3][4][5] | |
Chrisstanleyite, Ag2Pd3Se4, is a selenide mineral that crystallizes in high saline, acidic hydrothermal solution at low temperatures as part of selenide vein inclusions in and alongside
Composition
The chemical formula of chrisstanleyite is Ag2Pd3Se4 and contains trace amounts of Cu (Paar et al. 1998). Based on the sample received from Hope's Nose, England, Paar (1998) was able to utilize 7 grains in two polished sections to run 26 electron-microprobe analyses. The results of the analysis allowed Paar et al. (1998) to derive the average composition as (Ag2.01Cu0.02)Σ2.03Pd3.02Se3.95, or the ideal formula of Ag2Pd3Se4. The weight percent per element to create the ideal formula is Pd 37.52, Ag 25.36, Se 37.12, totaling 100% (Paar et al. 1998).
The presence of Cu in the sample proved important as the discovery of chrisstanleyite in the Pilbara Region of Western Australia found intergrown with an unnamed Cu-dominant equivalent (Nickel 2002). In 2004, this unknown mineral was officially named jagueite, Cu2Pd3Se4, after being found in El Chire, Argentina (Paar et al. 2004) and has been identified to form a solid-solution with chrisstanleyite (Paar et al. 1998; Nickel 2002; Paar et al. 2004).
Geologic occurrence
Chrisstanleyite occurs in selenide inclusions in and along calcite veins that cut through limestone (Paar et al. 2004). A selenide vein 10 cm below a calcite vein in Hope's Nose, where chrisstanleyite was initially identified, reflected a well-defined zoned sequence of minerals. The top of the sequence included native gold with small amounts of silver, while the middle layer consisted of palladian gold. The bottom layer consisted of selenide mineralization, primarily made of fischesserite (Paar et al. 1998).
Chrisstanleyite was identified in a second deposit, a
A third deposit of chrisstanleyite was found in El Chire, La Rioja, Argentina in a cutting calcite vein containing only one selenide-bearing vein through a hematite-rich sandstone and arkose host rocks. These rocks, similar to those from the Pilbara Region in Australia, were hydrothermally altered. The selenide vein included similar minerals tiemannite HgSe, naumannite, clausthalite, umangite, klockmannite, chrisstanleyite, and jagueite. It was identified that the grains of chrisstanleyite were surrounded by a rim of unnamed platinum-group metals, which were too thin to extract for identification, though it is associated with a silvery-mercury alloy. This allowed determination of crystallization for the selenide assemblage: chrisstanleyite and jagueite → (clausthalite) → naumannite and tiemannite → umangite and klockmannite → Pd-free native gold (Paar et al. 2004).
Structure
The crystal structure for chrisstanleyite has two different
The second framework consists of single coordination squares of Pd1 and paired Pd2 polyhedra, which create a zig-zag composition. These Pd2 polyhedra are layered at an angle (010) and interconnected by the Pd1 squares. This then creates the c
Stability in the two frameworks is created by the metal-metal bonds in the direction of [210]. These interconnect the metal atoms of one [010] layer of the zig-zag structure, as well as taking the Pd2 arrangement of both adjacent layers. The linear arrangement of these three layers creates stability for the creased angles of the Pd2 zig-zag pattern (Topa et al. 2006).
The structures found in chrisstanleyite and jagueite appear to be different from that of any other mineral. Comparing these with other Pd and Pt sulfides and selenides, no relations have been found. The closest structure found was with KCuPdSe5, which also forms corrugated layers, but the diagonally stacked squares are only one polyhedron deep. Additionally, the distances of Pd-Cu structures are not that of metal-metal bonds. Topa et al. (2006) concluded that chrisstanleyite and jagueite are a new structure type lacking a sulfide counterpart.
Special characteristics
A prominent feature chrisstanleyite has and shares with oosterboschite is that it has fine polysynthetic and parquet-like twinning. The difference between the two is that chrisstanleyite anisotropic rotation tints is much more colorful (Paar et al. 1998). Chrisstanleyite, also, forms a limited solid-solution with jagueite (Nickel 2002; Paar et al. 2004). Based on samples found in the Pilbara Region, the two minerals were both yellow and indistinguishable in reflected light and had weak bireflectance and moderate anisotropy (Nickel 2002).
See also
Notes
- S2CID 235729616.
- ^ Mineralienatlas
- ^ Webmineral.com
- ^ a b Mindat.org
- ^ Paar et al. 1998
References
- http://www.mindat.org/user-8203.html#0
- http://webmineral.com/data/Chrisstanleyite.shtml
- http://www.mindat.org/min-1028.html
- Nickel E.H. (2002): An unusual occurrence of Pd, Pt, Au, Ag, AND Hg Minerals in the Pilbara Region of Western Australia. The Canadian Mineralogist, 40, 419–433.
- Paar W.H., Roberts A.C., Criddle A.J., Topa D. (April 1998): A new mineral, chrisstanleyite, Ag2Pd3Se4, from Hope's Nose, Torquay, Devon, England. Mineralogical Magazine, 62(2), 257–264.
- Paar W.H., Topa D., Makovicky E., Sureda R.J., de Brodtkorb M.K., Nickel E.H., and Putz H. (2004): Jagueite, Cu2Pd3Se4, a new mineral species from El Chire, La Rioja, Argentina. The Canadian Mineralogist, 42: 1745–1755.
- Topa D., Makovicky E., Balic-Zunic T. (2006): The crystal structures of jagueite, Cu2Pd3Se4, and chrisstanleyite, Ag2Pd3Se4. The Canadian Mineralogist, 44, 497–505.