Single-molecule magnet
A single-molecule magnet (SMM) is a
Although the term "single-molecule magnet" was first employed in 1996,[3] the first single-molecule magnet, [Mn12O12(OAc)16(H2O)4] (nicknamed "Mn12") was reported in 1991.[4][5][6] This manganese oxide compound features a central Mn(IV)4O4 cube surrounded by a ring of 8 Mn(III) units connected through bridging oxo ligands, and displays slow magnetic relaxation behavior up to temperatures of ca. 4 K.[7][8]
Efforts in this field primarily focus on raising the operating temperatures of single-molecule magnets to liquid nitrogen temperature or room temperature in order to enable applications in magnetic memory. Along with raising the blocking temperature, efforts are being made to develop SMMs with high energy barriers to prevent fast spin reorientation.[9] Recent acceleration in this field of research has resulted in significant enhancements of single-molecule magnet operating temperatures to above 70 K.[10][11][12][13]
Measurement
Arrhenius behavior of magnetic relaxation
Because of single-molecule magnets'
where:
- τ is the magnetic relaxation time, or the average amount of time that it takes for the molecule's magnetization to randomly flip as a result of thermal fluctuations
- τ0 is a length of time, characteristic of the material, called the attempt time or attempt period (its reciprocal is called the attempt frequency); its typical value is between 10−9 and 10−10 second
- Ueff is the cm−1 or in kelvins.
- kB is the Boltzmann constant
- T is the temperature
This magnetic relaxation time, τ, can be anywhere from a few nanoseconds to years or much longer.
Magnetic blocking temperature
The so-called magnetic blocking temperature, TB, is defined as the temperature below which the relaxation of the magnetization becomes slow compared to the time scale of a particular investigation technique.[15] Historically, the blocking temperature for single-molecule magnets has been defined as the temperature at which the molecule's magnetic relaxation time, τ, is 100 seconds. This definition is the current standard for comparison of single-molecule magnet properties, but otherwise is not technologically significant. There is typically a correlation between increasing an SMM's blocking temperature and energy barrier. The average blocking temperature for SMMs is 4K.[16] Dy-metallocenium salts are the most recent SMM to achieve the highest temperature of magnetic hysteresis, greater than that of liquid nitrogen.[9]
Intramolecular magnetic exchange
The magnetic coupling between the spins of the metal ions is mediated by
where is the coupling constant between spin i (operator ) and spin j (operator ). For positive J the coupling is called ferromagnetic (parallel alignment of spins) and for negative J the coupling is called antiferromagnetic (antiparallel alignment of spins): a high spin ground state, a high zero-field-splitting (due to high magnetic anisotropy), and negligible magnetic interaction between molecules.
The combination of these properties can lead to an
Barrier to magnetic relaxation
A single-molecule magnet can have a positive or negative magnetic moment, and the energy barrier between these two states greatly determines the molecule's relaxation time. This barrier depends on the total spin of the molecule's ground state and on its magnetic anisotropy. The latter quantity can be studied with EPR spectroscopy.[21]
Performance
The performance of single-molecule magnets is typically defined by two parameters: the effective barrier to slow magnetic relaxation, Ueff, and the magnetic blocking temperature, TB. While these two variables are linked, only the latter variable, TB, directly reflects the performance of the single-molecule magnet in practical use. In contrast, Ueff, the
The table below lists representative and record 100-s magnetic blocking temperatures and Ueff values that have been reported for single-molecule magnets.
Complex | Type | TB (100-s; K) | Ueff (cm−1) | Ref. | Year Reported |
---|---|---|---|---|---|
[Mn12O12(OAc)16(H2O)4] | cluster | 3 K | 42 cm−1 | [5][4][6] | 1991 |
[K(18-crown-6)(THF)2][{[(Me3Si)2N]2(THF)Tb}2(μ-η2:η2-N2)] | cluster | 14 K | 227 cm−1 | [22] | 2011 |
Tb(CpiPr5)2 | single-ion | 52 K | 1205 cm−1 | [23] | 2019 |
[Dy(Cpttt)2][B(C6F5)4]* | single-ion | 56 K | 1219 cm−1 | [10][11] | 2017 |
[Dy(CpiPr4Me)2][B(C6F5)4] | single-ion | 62 K | 1468 cm−1 | [12] | 2018 |
[tBuPO(NHiPr)2Dy(H2O)][I3] | single-ion | 2.4 K | 452 cm−1 | [24] | 2016 |
[Dy(CpiPr4H)2][B(C6F5)4] | single-ion | 17 K | 1285 cm−1 | [12] | 2018 |
[Dy(CpiPr5)(CpMe5)][B(C6F5)4] | single-ion | 67 K | 1541 cm−1 | [13] | 2018 |
[Dy(CpiPr4Et)2][B(C6F5)4] | single-ion | 59 K | 1380 cm−1 | [12] | 2018 |
[Dy(CpiPr5)2][B(C6F5)4] | single-ion | 56 K | 1334 cm−1 | [12] | 2018 |
[Dy(OtBu)2(py)5][BPh4] | single-ion | 12 K | 1264 cm−1 | [25] | 2016 |
Abbreviations: OAc=acetate, Cpttt=1,2,4‐tri(tert‐butyl)cyclopentadienide, CpMe5= 1,2,3,4,5-penta(methyl)cyclopentadienide, CpiPr4H= 1,2,3,4-tetra(isopropyl)cyclopentadienide, CpiPr4Me= 1,2,3,4-tetra(isopropyl)-5-(methyl)cyclopentadienide, CpiPr4Et= 1-(ethyl)-2,3,4,5-tetra(isopropyl)cyclopentadienide, CpiPr5= 1,2,3,4,5-penta(isopropyl)cyclopentadienide
*indicates parameters from magnetically dilute samples[26]
Types
Metal clusters
Metal clusters formed the basis of the first decade-plus of single-molecule magnet research, beginning with the archetype of single-molecule magnets, "Mn12".[4][5][6] This complex is a polymetallic manganese (Mn) complex having the formula [Mn12O12(OAc)16(H2O)4], where OAc stands for acetate. It has the remarkable property of showing an extremely slow relaxation of their magnetization below a blocking temperature. [Mn12O12(OAc)16(H2O)4]·4H2O·2AcOH, which is called "Mn12-acetate" is a common form of this used in research.[27]
Single-molecule magnets are also based on
The ferrous cube complex [Fe4(sae)4(MeOH)4] was the first example of a single-molecule magnet involving an Fe(II) cluster, and the core of this complex is a slightly distorted cube with Fe and O atoms on alternating corners.[28] Remarkably, this single-molecule magnet exhibits non-collinear magnetism, in which the atomic spin moments of the four Fe atoms point in opposite directions along two nearly perpendicular axes.[29] Theoretical computations showed that approximately two magnetic electrons are localized on each Fe atom, with the other atoms being nearly nonmagnetic, and the spin–orbit-coupling potential energy surface has three local energy minima with a magnetic anisotropy barrier just below 3 meV.[30]
Applications
Due to the typically large, bi-stable spin
Theoretically, quantum computers can overcome the physical limitations presented by classical computers by encoding and decoding quantum states. Single-molecule magnets have been utilized for the Grover algorithm, a quantum search theory.[34] The quantum search problem typically requests for a specific element to be retrieved from an unordered database. Classically the element would be retrieved after N/2 attempts, however a quantum search utilizes superpositions of data in order to retrieve the element, theoretically reducing the search to a single query. Single molecular magnets are considered ideal for this function due to their cluster of independent spins. A study conducted by Leuenberger and Loss, specifically utilized crystals to amplify the moment of the single spin molecule magnets Mn12 and Fe8. Mn12 and Fe8 were both found to be ideal for memory storage with a retrieval time of approximately 10−10 seconds.[34]
Another approach to information storage with SMM Fe4 involves the application of a gate voltage for a state transition from neutral to anionic. Using electrically gated molecular magnets offers the advantage of control over the cluster of spins during a shortened time scale.[33] The electric field can be applied to the SMM using a tunneling microscope tip or a strip-line. The corresponding changes in conductance are unaffected by the magnetic states, proving that information storage could be performed at much higher temperatures than the blocking temperature.[16] The specific mode of information transfer includes DVD to another readable medium, as shown with Mn12 patterned molecules on polymers.[35]
Another application for SMMs is in magnetocaloric refrigerants . A machine learning approach using experimental data has been able to predict novel SMMs that would have large entropy changes, and therefore more suitable for magnetic refrigeration. Three hypothetical SMMs are proposed for experimental synthesis:, , .[36] The main SMM characteristics that contribute to the entropy properties include dimensionality and the coordinating ligands.
In addition, single-molecule magnets have provided physicists with useful test-beds for the study of
See also
- Ferromagnetism
- Antiferromagnetism
- Magnetic anisotropy
- Single-molecule experiment
- Magnetism
- Superparamagnetism
- Magnetochemistry
References
- ^ ISSN 0883-7694.
- ^ a b c Introduction to Molecular Magnetism by Dr. Joris van Slageren.
- .
- ^ .
- ^ ISSN 0002-7863.
- ^ S2CID 4235125.
- .
- ^ Chemistry of Nanostructured Materials; Yang, P., Ed.; World Scientific Publishing: Hong Kong, 2003.
- ^ PMID 30756104.
- ^ PMID 28586163.
- ^ S2CID 4454501.
- ^ PMID 30568773.
- ^ PMID 30337456.
- ISBN 978-2-88124-300-4.). [verification needed]
- ^ doi:10.1039/a908254i..
- ^ ISSN 2046-2069.
- ^ Frustrated Magnets Archived March 14, 2008, at the Wayback Machine, Leibniz Institute for Solid State and Materials Research, Dresden, Germany.
- ^ Molecular Magnetism Web Introduction page.
- ^ ScienceDaily (Mar. 27, 2000) article Several New Single-Molecule Magnets Discovered.
- ^ National Physical Laboratory (UK) Home > Science + Technology > Quantum Phenomena > Nanophysics > Research – article Molecular Magnets.
- PMID 19248077.
- S2CID 207071708.
- S2CID 199388151.
- PMID 30155168.
- PMID 27874236.
- S2CID 147706997.
- .
- .
- PMID 15250734.
- PMID 26598359.
- PMID 18231680.
- PMID 18369484.
- ^ ISSN 0020-1693.
- ^ S2CID 4373008.
- ISSN 1521-3757.
- S2CID 197477060.
- PMID 12548682.
- PMID 10102810.
External links
- Molecular Magnetism Web, Jürgen Schnack