Optical storage media writing and reading speed

Edit links
Source: Wikipedia, the free encyclopedia.

In the

history of optical storage media
there have been and there are different optical disc formats with different data writing/reading speeds.

Original

compact disc players without buffering. As faster drives were released, the write speeds and read speeds for optical discs were multiplied by manufacturers, far exceeding the drive speeds originally released onto the market. In order to market increasing drive speeds, manufacturers used the symbol n×, whereby n is the multiple of the original speed. For example, writing to a CD at 8× will be twice as fast as writing onto a disc at 4×.[2]

There are two main types of disc speed, which are the angular and linear velocities. If the disc spins at a constant angular velocity, the linear velocity is 2.4 times higher at the outer edge.

Various optical disc formats writing/reading speeds

Comparison of various optical storage media. Parameters: track pitch (p), pit width (w) and minimum length (l), and laser spot size (⌀) and wavelength (λ).
Media 1× sequential speed Capacity of a single layer (decimal)
 Capacity of a single layer (binary)
 Full read time
(min)[3]
Mbit/s
kB/s
MB/s
CD
 1.229 153.6 0.15 734 MB 700 MiB 80
DVD 11.080 1385.0 1.38 4.7 GB 4.38 GiB 57
HD DVD 36.000 4500.0 4.5 15.0 GB 13.96 GiB 56
Blu-ray 25.0 GB 23.28 GiB 90

Modern compact discs support a writing speed of 52× and higher, with some modern DVDs supporting speeds of up to 24×.[4] Writing a DVD at 1× (1385000 bytes per second)[5] is approximately 9 times faster than writing a CD at 1× (153600 bytes per second).[6] However, the actual speeds depend on the type of data being written to the disc.[6]

For

Red Book (audio CD standard) specifies for a digital audio CD (CD-DA); although now, most recordable CDs can hold 80 minutes worth of data. The DVD and Blu-ray discs hold a higher capacity of data, so reading or writing those discs in the same 74-minute time-frame requires a higher data transfer rate. Drive speed can be limited intentionally to reduce noise from the drive or slow down ripping, such as the firmware component Riplock
.

In video games

Since their debut on various optical storage media during the fifth up to before the seventh generation (1994–2005), the size of data in video games did not require an installation on a non-optical support and the reading speed of optical drives was enough so that data could be read directly from optical discs. As seventh generation video games caught on, the size of data, higher quality texture mapping etc., required in turn a higher stream of data coming out of optical storage media. A gap was becoming evident between design/graphics needs and technological limitations of reading speed/transfer rate.

Video games for PlayStation 3 were stored on single-layer Blu-ray which has a higher transfer rate by default but the console's optical drive speed multiplier was set at 2× (9 MB/s). On Xbox 360, video games were stored on common dual-layer 8.5 GB DVDs but with the console's 12× drive speed multiplier (16.5 MB/s), Xbox 360 could achieve up to 85% faster data transfer rate than PlayStation 3.[8] Slower transfer rate on PlayStation 3 led many multi-platform developers for a mandatory installation of a portion of the disc's content on the console's hard disk drive (HDD) in order to offset problems such as longer loading times.[9][10][11][12] Xbox 360 could install games entirely on HDD and potentially improve loading times but this was never mandatory.[13] Optical discs were still required to boot games. Seventh generation video games rarely filled the space of an entire single-layer Blu-ray disc (25 GB) or required two or more DVDs on Xbox 360.

From the eighth generation onward, full 1080p high-definition graphics, higher quality textures, further required a higher stream of data and as such Blu-ray optical drives' reading speed at 6× (27 MB/s)[14] soon proved to be insufficient.[15] For this reason, consoles like PlayStation 4 force-install video games entirely on HDD, which allows a higher stream of data. Like it was for Xbox 360, optical discs are still required to boot games.[15]

Theoretical versus practical writing speed

Almost all modern CD/DVD-burning software supports a selection of speeds at which the writable disc can be written. However, the option a user chooses only defines the theoretical maximum of disc burning process. There are other factors that influence the time taken for a disc to be written to:

Optimal writing speed

A higher writing speed results in a faster disc burn, but the optical quality may be lower (i.e. the disc is less reflective). If the reflectivity is too low for the disc to be read accurately, some parts may be skipped or it may result in unwanted audio artifacts such as squeaking and clicking sounds. For optimal results, it is suggested that a disc be burnt at its rated speed.[16][17]

See also

References

  1. ^ "CD-ROM". thefreedictionary.com. Retrieved February 23, 2023. Back in the late 1980s, the first CD-ROM drives transferred data at 150 KB per second.
  2. ^ "What is Read Speed? What is Write Speed?". Misco. Archived from the original on October 2, 2011. Retrieved August 26, 2021.
  3. ^ Full read time of a single layer. Full read time can be increased, adding more minutes by adding layers and/or using compression techniques, lowering content quality.
  4. ^ "Three Generations Compared: Is Your DVD Burner Outdated?". Tom's Hardware. October 30, 2009. Retrieved August 26, 2021.
  5. ^ "Understanding Recordable & Rewritable DVD recording speed". OSTA. Retrieved August 26, 2021.
  6. ^ a b "Understanding CD-R and CD-RW recording speed". OSTA. Retrieved August 26, 2021.
  7. ^ "Blu-ray writing speed". Blu-ray.com. Retrieved August 26, 2021.
  8. ^ "Is Blu-ray really a good medium for games?". Ars Technica. January 17, 2007. Retrieved February 23, 2023.
  9. ^ "Why some PS3 games need installation". Joystiq. April 2, 2008. Archived from the original on April 5, 2008. Retrieved August 26, 2021.
  10. ^ "The Mystery Behind PlayStation 3's Sometimes Mandatory Installations". MTV. April 1, 2008. Archived from the original on April 5, 2008. Retrieved August 26, 2021.
  11. ^ "Capcom addresses DMC4 install complaints". Joystiq. February 5, 2008. Archived from the original on February 7, 2008. Retrieved August 26, 2021.
  12. ^ "GTA IV for PS3 Has Mandatory Install, Xbox 360 Install Is Optional". Softpedia. April 17, 2008. Retrieved August 26, 2021.
  13. ^ "Install, play, or delete a game on your Xbox 360 hard drive". Microsoft. Retrieved August 26, 2021.
  14. ^ "Spec Analysis: PlayStation 4". Eurogamer. February 21, 2023. Retrieved February 23, 2023. The Blu-ray reader gets a decent enough upgrade from PS3's 2x drive, moving up to a 6x CAV (constant angular velocity) design, meaning maximum read speeds of around 27 MB/s.
  15. ^ a b "PlayStation 4 installs every game to its hard drive (even disc-based titles)". VentureBeat. October 30, 2013. Retrieved February 23, 2022.
  16. ^ Robjohns, Hugh (November 2004). "Why does the speed at which you burn a CD make a difference?". SoundOnSound. Retrieved August 26, 2021.
  17. ^ "Which write speed should I use?". Feurio. Archived from the original on February 1, 2010. Retrieved August 26, 2021.
Retrieved from "https://en.wikipedia.org/w/index.php?title=Optical_storage_media_writing_and_reading_speed&oldid=1220413522"