Photocatalytic water splitting
This article needs attention from an expert in Chemistry. The specific problem is: article lacks perspective and overview.(October 2021) |
Photocatalytic water splitting is a process that uses
Concepts
Two mole of H2O is split into 1 mole O
2 and 2 mole H
2 using light in the process shown below.
A photon with an energy greater than 1.23 eV is needed to generate an electron–hole pairs, which react with water on the surface of the photocatalyst. The photocatalyst must have a bandgap large enough to split water; in practice, losses from material internal resistance and the overpotential of the water splitting reaction increase the required bandgap energy to 1.6–2.4 eV to drive water splitting.[2]
The process of water-splitting is a highly endothermic process (ΔH > 0). Water splitting occurs naturally in photosynthesis when the energy of four photons is absorbed and converted into chemical energy through a complex biochemical pathway (Dolai's or Kok's S-state diagrams).[3]
O–H bond homolysis in water requires energy of 6.5 - 6.9 eV (UV photon).[4][5] Infrared light has sufficient energy to mediate water splitting because it technically has enough energy for the net reaction. However, it does not have enough energy to mediate the elementary reactions leading to the various intermediates involved in water splitting (this is why there is still water on Earth). Nature overcomes this challenge by absorbing four visible photons. In the laboratory, this challenge is typically overcome by coupling the hydrogen production reaction with a sacrificial reductant other than water.[6]
Materials used in photocatalytic water splitting fulfill the band requirements and typically have dopants and/or
2) and is typically used with a co-catalyst such as platinum (Pt) to increase the rate of H
2 production.[7] A major problem in photocatalytic water splitting is photocatalyst decomposition and corrosion.[7]
Method of evaluation
Photocatalysts must conform to several key principles in order to be considered effective at water splitting. A key principle is that H
2 and O
2 evolution should occur in a
- QY (%) = (Photochemical reaction rate) / (Photon absorption rate) × 100%[7]
To assist in comparison, the rate of gas evolution can also be used. A photocatalyst that has a high quantum yield and gives a high rate of gas evolution is a better catalyst.
The other important factor for a photocatalyst is the range of light that is effective for operation. For example, a photocatalyst is more desirable to use visible photons than UV photons.
Photocatalysts
The efficiency of solar-to-hydrogen (STH) of photocatalytic water splitting, however, has remained very low.
Gallium-indium nitride
A STH efficiency of 9.2% indium.[8]
NaTaO
3:La
NaTaO
3:La yielded the highest water splitting rate of photocatalysts without using sacrificial reagents.[7] This ultraviolet-based photocatalyst was reported to show water splitting rates of 9.7 mmol/h and a quantum yield of 56%. The nanostep structure of the material promotes water splitting as edges functioned as H
2 production sites and the grooves functioned as O
2 production sites. Addition of NiO particles as co-catalysts assisted in H
2 production; this step used an impregnation method with an aqueous solution of Ni(NO
3)
2•6H
2O and evaporated the solution in the presence of the photocatalyst. NaTaO
3 has a conduction band higher than that of NiO, so photo-generated electrons are more easily transferred to the conduction band of NiO for H
2 evolution.[9]
K
3Ta
3B
2O
12
K
3Ta
3B
2O
12 is another catalyst solely activated by UV and above light. It does not have the performance or quantum yield of NaTaO
3:La. However, it can split water without the assistance of co-catalysts and gives a quantum yield of 6.5%, along with a water splitting rate of 1.21 mmol/h. This ability is due to the pillared structure of the photocatalyst, which involves TaO
6 pillars connected by BO
3 triangle units. Loading with NiO did not assist the photocatalyst due to the highly active H
2 evolution sites.[10]
(Ga
.82Zn
.18)(N
.82O
.18)
(Ga
.82Zn
.18)(N
.82O
.18) had the highest quantum yield in visible light for visible light-based photocatalysts that do not utilize sacrificial reagents as of October 2008.[7] The photocatalyst featured a quantum yield of 5.9% and a water splitting rate of 0.4 mmol/h. Tuning the catalyst was done by increasing calcination temperatures for the final step in synthesizing the catalyst. Temperatures up to 600 °C helped to reduce the number of defects, while temperatures above 700 °C destroyed the local structure around zinc atoms and were thus undesirable. The treatment ultimately reduced the amount of surface Zn and O defects, which normally function as recombination sites, thus limiting photocatalytic activity. The catalyst was then loaded with Rh
2-yCr
yO
3 at a rate of 2.5 wt% Rh and 2 wt% Cr for better performance.[11]
Molecular catalysts
Proton reduction catalysts based on earth-abundant elements[12][13] carry out one side of the water-splitting half-reaction.
A mole of octahedral nickel(II) complex, [Ni(bztpen)]2+ (bztpen = N-benzyl-N,N’,N’-tris(pyridine-2-ylmethyl)ethylenediamine) produced 308,000 moles of hydrogen over 60 hours of electrolysis with an applied potential of -1.25 V vs. standard hydrogen electrode.[14]
Ru(II) with three 2,2'-bipyridine ligands is a common compound for photosensitization used for photocatalytic oxidative transformations like water splitting. However, the bipyridine degrades due to the strongly oxidative conditions which causes the concentration of Ru(bpy)32+ to diminish. Measurements of the degradation is difficult with UV-Vis spectroscopy but MALDI MS can be used instead.[15]
In 2014 researchers announced an approach that connected a chromophore to part of a larger organic ring that surrounded a cobalt atom. The process is less efficient than a platinum catalyst although cobalt is less expensive, potentially reducing costs. The process uses one of two supramolecular assemblies based on Co(II)-templated coordination of Ru(bpy)+32 (bpy = 2,2′-bipyridyl) analogues as photosensitizers and electron donors to a cobaloxime macrocycle. The Co(II) centers of both assemblies are high spin, in contrast to most previously described cobaloximes. Transient absorption optical spectroscopies indicate that charge recombination occurs through multiple ligand states within the photosensitizer modules.[17][18]
Bismuth vanadate
Bismuth oxides
Bismuth oxides are characterized by visible light absorption properties, just like vanadates.[26][27]
Tungsten diselenide (WSe2)
Tungsten diselenide has photocatalytic properties that might be a key to more efficient electrolysis.[28]
III-V semiconductor systems
Systems based on
2D semiconductor systems
2-dimensional semiconductors such as MoS
2 are actively researched as potential photocatalysts.[30][31]
Aluminum‐based metal-organic frameworks
An aluminum‐based
Porous organic polymers
Organic semiconductor photocatalysts, in particular porous organic polymers (POPs), attracted attention due to their low cost, low toxicity, and tunable light absorption vs inorganic counterparts.[33][34][35] They display high porosity, low density, diverse composition, facile functionalization, high chemical/thermal stability, as well as high surface areas.[36] Efficient conversion of hydrophobic polymers into hydrophilic polymer nano-dots (Pdots) increased polymer-water interfacial contact, which significantly improved performance.[37][38][39]
Ansa-Titanocene(III/IV) Triflate Complexes
Beweries, et al., developed a light-driven "closed cycle of water splitting using ansa-titanocene(III/IV) triflate complexes".[40]
Indium gallium nitride
An
Sacrificial reagents
Cd
1-xZn
xS
Solid solutions Cd
1-xZn
xS with different Zn concentration (0.2 < x < 0.35) have been investigated in the production of hydrogen from aqueous solutions containing as sacrificial reagents under visible light.[42] Textural, structural and surface catalyst properties were determined by N
2 adsorption isotherms, UV–vis spectroscopy, SEM and XRD and related to the activity results in hydrogen production from water splitting under visible light. It was reported that the crystallinity and energy band structure of the Cd
1-xZn
xS solid solutions depend on their Zn atomic concentration. The hydrogen production rate increased gradually as Zn concentration on photocatalysts increased from 0.2 to 0.3. The subsequent increase in the Zn fraction up to 0.35 reduced production. Variation in photoactivity was analyzed for changes in crystallinity, level of the conduction band and light absorption ability of Cd
1-xZn
xS solid solutions derived from their Zn atomic concentration.
Further reading
- Chu, Sheng; Li, Wei; Hamann, Thomas; Shih, Ishiang; Wang, Dunwei; Mi, Zetian (2017). "Roadmap on solar water splitting: current status and future prospects". Nano Futures. 1 (2): 022001. S2CID 3903962.
- Takata, Tsuyoshi; Jiang, Junzhe; Sakata, Yoshihisa; Nakabayashi, Mamiko; Shibata, Naoya; Nandal, Vikas; Seki, Kazuhiko; Hisatomi, Takashi; Domen, Kazunari (2020-05-28). "Photocatalytic water splitting with a quantum efficiency of almost unity". Nature. 581 (7809): 411–414. S2CID 218912943.
- del Valle, F.; Álvarez Galván, M. Consuelo; Del Valle, F.; Villoria De La Mano, José A.; Fierro, José L. G.; et al. (Jun 2009). "Water Splitting on Semiconductor Catalysts under Visible-Light Irradiation". ChemSusChem. 2 (6): 471–485. PMID 19536754.
- del Valle, F.; Del Valle, F.; Villoria De La Mano, J.A.; Álvarez-Galván, M.C.; Fierro, J.L.G.; et al. (2009). "Advances in Chemical Engineering". Photocatalytic water splitting under visible Light: concept and materials requirements. Vol. 36. pp. 111–143. ISBN 9780123747631.
See also
- Artificial photosynthesis
- High-temperature electrolysis
- Photochemical reduction of carbon dioxide
- Electrolysis of water
- Photoelectrolysis of water
References
- PMID 19088977.
- ^ PMID 30855624.
- PMID 24684576.
- PMID 26630000.
- S2CID 4251015.
- S2CID 251852086.
- ^ PMID 19088977.
- PMID 36600066.
- PMID 12617675.
- ^ T. Kurihara, H. Okutomi, Y. Miseki, H. Kato, A. Kudo, "Highly Efficient Water Splitting over K
3Ta
3B
2O
12Photocatalyst without Loading Cocatalyst" Chem. Lett., 35, 274 (2006). - ^ K. Maeda, K. Teramura, K. Domen,
"Effect of post-calcination on photocatalytic activity of (Ga
1-xZn
x)(N
1-xO
x) solid solution for overall water splitting under visible light" J. Catal., 254, 198 (2008). - ISSN 2041-6520.
- .
- PMID 25277377.
- ISSN 1759-9660.
- PMID 21748828.
- PMID 24220293. Retrieved 2014-01-23.
- PMID 24220293.
- S2CID 198742844.
- ^ Shafiq, I. (2018). Mesoporous monoclinic BiVO4 for efficient visible light driven photocatalytic degradation of dyes (Doctoral dissertation, COMSATS University Islamabad, Lahore Campus.).
- PMID 23893238.
- .
- PMID 26053164.
- S2CID 125395272.
- S2CID 139703154.
- .
- S2CID 95775856.
- ^ "Discovery Brightens Solar's Future, Energy Costs to Be Cut". NBC News. NBC News from Reuters. July 2, 2015. Retrieved July 2, 2015.
- PMID 26369620.
- PMID 26961514.
- ISSN 2044-4753.
- PMID 28170148.
- PMID 16497885.
- PMID 25136991.
- PMID 26593389.
- ISSN 2052-1537.
- PMID 27604393.
- ISSN 1754-5706.
- PMID 32329950.
- PMID 26641723.
- S2CID 255474993.
- .