Supercritical carbon dioxide blend
Supercritical carbon dioxide blend (sCO2 blend) is an homogeneous
Carbon dioxide behaves as a supercritical fluid above its critical temperature (304.13 K, 31.0 °C, 87.8 °F) and critical pressure (7.3773 MPa, 72.8 atm, 1,070 psi, 73.8 bar), expanding to fill its container like a gas but with a density like that of a liquid.[2]
By combining CO2 with other fluids, the critical temperature and critical pressure of the mixture can be modified. The s-CO2 blend is usually designed to increase the mixture supercritical temperature to employ the s-CO2 in power cycles, obtaining increased energy conversion efficiency.[3]
Applications
Power generation
Despite the development of new electricity generation technologies, most power plants are thermal power stations, meaning that they use a heat source (solar thermal, nuclear power, fossil fuel, biomass, Incineration, geothermal) to produce electricity. Although this process can be achieved directly by using the seebeck effect, the power conversion efficiency is greatly increased by using a power cycle. Traditionally, power plants are based on Rankine cycle and use steam turbines for electricity generation. The efficiency of the power cycle is limited by the temperature difference between the heat source and the heat sink. The greater the differential, the more electricity can be produced. Replacing steam by supercritical carbon dioxide allows reaching a higher temperature differential, therefore increasing the power efficiency of the power plant.[3]
Supercritical state facilitates the heat exchange at the heat source. Furthermore, supercritical carbon dioxide is twice as dense as steam, and the combination of high density and volumetric heat makes it a high energy dense fluid, meaning that the size of most components of the thermodynamic cycle can be reduced. Therefore, the ecological footprint of the plant and the capital expenditure are considerably reduced. In addition, sCO2 is non-flammable, non-toxic, non-explosive and cheap.[4] Efficiency can be further increased employing a combined cycle.[5]
One of the main limitations that has delayed the massive use of carbon dioxide in power cycles is the
.Concentrated Solar Power
Concentrated solar power (CSP) is a solar thermal technology that uses mirrors or lenses to concentrate sunlight into a receiver.[6] The receiver reaches very high temperatures, up to 1000 °C for commercial solar power towers, favouring high power conversion efficiency. However, electricity production is limited by the heat engine used.[3]
In the Concentrated Solar Power sector, using supercritical CO2 as the heating engine fluid can provide a significant cost reduction. The higher efficiency of the power block reduces the solar field size, decreasing the soil occupation and therefore the cost of this part of the plant. According to the available analyses, electricity production costs of conventional supercritical CO2 CSP are expected to be 9,5–10 $ cent/KWh in favorable conditions.[7] In addition, Concentrated Solar Power offers the possibility of directly recovering solar radiation without using any intermediate energy carrier. However, this poses challenges in the design of high pressure solar receivers, that must held pressures above the critical pressure of the fluid, as well as energy storage systems.[8]
Efficient supercritical CO2 power cycles requires that the compressor inlet temperature is close to, or even lower than, the critical temperature of the fluid (31 °C for pure carbon dioxide). When this target is reached, and the heat source is higher than 600–650 °C, then the sCO2 cycle outperforms any Rankine cycle running on water/steam with the same boundary conditions.[9]
Because of the weather conditions in
| Dopant fluid (%molar) | Molar weight (g/mol) | Critical temperature (°C) | Critical pressure (bar) |
|---|---|---|---|
| C6F6 (10) | 58.21 | 80.28 | 112.4 |
| C6F6 (15) | 65.32 | 102.1 | 121.3 |
| C6F6 (20) | 72.42 | 121.9 | 123.6 |
| TiCl4 (15) | 65.86 | 93.76 | 190.9 |
| TiCl4 (20) | 73.15 | 149.6 | 243.7 |
SCARABEUS project, which has received funding from the European Union, formulates a new conceptual approach to implement supercritical carbon dioxide blends in Concentrated Solar Power Plants to reduce operating and capital costs by increasing the power cycle efficiency. The SCARABEUS project is developed by a consortium of European universities (Politecnico di Milano and Università degli Studi di Brescia from Italy, Technische Universität Wien from Austria, Universidad de Sevilla from Spain and University of London from United Kingdom) and private companies(Kelvion from Germany, Baker Hughes from United States and Abengoa from Spain) with experience in Concentrated Solar Power.[11][12]
See also
References
- ^ "Supercritical CARbon dioxide/Alternative fluids Blends for Efficiency Upgrade of Solar power plant". ResearchGate.
- ISSN 0047-2689.
- ^ .
- ^ Patel, Sonal (April 1, 2019). "What Are Supercritical CO2 Power Cycles?". POWER Magazine. Retrieved December 15, 2022.
- ^ "Combined cycles – techouse". Archived from the original on December 15, 2022. Retrieved December 15, 2022.
- ^ Kraemer, Susan (June 11, 2018). "How CSP Works: Tower, Trough, Fresnel or Dish". SolarPACES. Retrieved December 7, 2022.
- OCLC 1240072375.)
{{cite book}}: CS1 maint: multiple names: authors list (link - S2CID 216291655.
- ^ ISSN 2076-3417.
- ^ )
- doi:10.3030/814985.
- ^ "Scarabeusproject". Retrieved December 7, 2022.