Barrier island
This article needs additional citations for verification. (May 2018) |
Barrier islands are a
Chains of barrier islands can be found along approximately 13-15% of the world's coastlines.[5] They display different settings, suggesting that they can form and be maintained in a variety of environments. Numerous theories have been given to explain their formation.
A human-made offshore structure constructed parallel to the shore is called a breakwater. In terms of coastal morphodynamics, it acts similarly to a naturally occurring barrier island by dissipating and reducing the energy of the waves and currents striking the coast. Hence, it is an important aspect of coastal engineering.
Constituent parts
- Upper shoreface
The shoreface is the part of the barrier where the ocean meets the shore of the island. The barrier island body itself separates the shoreface from the backshore and
- Middle shoreface
The middle shoreface is located in the upper shoreface. The middle shoreface is strongly influenced by wave action because of its depth. Closer to shore the sand is medium-grained, with shell pieces common. Since wave action is heavier, bioturbation is not likely.
- Lower shoreface
The
- Foreshore
The
- Backshore
The backshore is always above the highest water level point. The berm is also found here which marks the boundary between the foreshore and backshore. Wind is the important factor here, not water. During strong storms high waves and wind can deliver and erode sediment from the backshore.
- Dunes
Coastal dunes, created by wind, are typical of a barrier island. They are located at the top of the backshore. The dunes will display characteristics of typical aeolian wind-blown dunes. The difference is that dunes on a barrier island typically contain coastal vegetation roots and marine bioturbation.
- Lagoon and tidal flats
The
Location
Barrier Islands can be observed on every continent on Earth, except Antarctica. They occur primarily in areas that are tectonically stable, such as "trailing edge coasts" facing (moving away from) ocean ridges formed by divergent boundaries of tectonic plates, and around smaller marine basins such as the Mediterranean Sea and the Gulf of Mexico.[6] Areas with relatively small tides and ample sand supply favor barrier island formation.
Australia
Moreton Bay, on the east coast of Australia and directly east of Brisbane, is sheltered from the Pacific Ocean by a chain of very large barrier islands. Running north to south they are Bribie Island, Moreton Island, North Stradbroke Island and South Stradbroke Island (the last two used to be a single island until a storm created a channel between them in 1896). North Stradbroke Island is the second largest sand island in the world and Moreton Island is the third largest.
Fraser Island, another barrier island lying 200 km north of Moreton Bay on the same coastline, is the largest sand island in the world.
United States
Barrier islands are found most prominently on the United States' East and Gulf Coasts, where every state—from Maine to Florida (East Coast) and from Florida to Texas (
Canada
Barrier Islands can also be found in Maritime Canada, and other places along the coast. A good example is found at
Mexico
Mexico's Gulf of Mexico coast has numerous barrier islands and barrier peninsulas.
New Zealand
Barrier islands are more prevalent in the north of both of New Zealand's main islands. Notable barrier islands in New Zealand include
India
The Vypin Island in the Southwest coast of India in Kerala is 27 km long. It is also one of the most densely populated islands in the world.
Indonesia
The Indonesian Barrier Islands lie off the western coast of
.Europe
Barrier islands can be observed in the Baltic Sea from Poland to Lithuania as well as distinctly in the
Processes
Migration and overwash
Water levels may be higher than the island during storm events. This situation can lead to overwash, which brings sand from the front of the island to the top and/or landward side of the island. This process leads to the evolution and migration of the barrier island.[9]
Critical width concept
Barrier islands are often formed to have a certain width. The term "critical width concept" has been discussed with reference to barrier islands, overwash, and washover deposits since the 1970s. The concept basically states that overwash processes were effective in migration of the barrier only where the barrier width is less than a critical value. The island did not narrow below these values because overwash was effective at transporting sediment over the barrier island, thereby keeping pace with the rate of ocean shoreline recession. Sections of the island with greater widths experienced washover deposits that did not reach the bayshore, and the island narrowed by ocean shoreline recession until it reached the critical width. The only process that widened the barrier beyond the critical width was breaching, formation of a partially subaerial flood shoal, and subsequent inlet closure.[10]
Critical barrier width can be defined as the smallest cross-shore dimension that minimizes net loss of sediment from the barrier island over the defined project lifetime. The magnitude of critical width is related to sources and sinks of sand in the system, such as the volume stored in the dunes and the net long-shore and cross-shore sand transport, as well as the island elevation.[11] The concept of critical width is important for large-scale barrier island restoration, in which islands are reconstructed to optimum height, width, and length for providing protection for estuaries, bays, marshes and mainland beaches.[12]
Formation theories
Scientists have proposed numerous explanations for the formation of barrier islands for more than 150 years. There are three major theories: offshore bar, spit accretion, and submergence.[3] No single theory can explain the development of all barriers, which are distributed extensively along the world's coastlines. Scientists accept the idea that barrier islands, including other barrier types, can form by a number of different mechanisms.[13]
There appears to be some general requirements for formation. Barrier island systems develop most easily on wave-dominated coasts with a small to moderate tidal range. Coasts are classified into three groups based on
Offshore bar theory
In 1845 the Frenchman
Several barrier islands have been observed forming by this process along the Gulf coast of the Florida peninsula, including: the North and South Anclote Bars associated with Anclote Key, Three Rooker Island, Shell Key, and South Bunces Key.[16]
Spit accretion theory
American geologist
Submergence theory
Along the coast of
Boulder Bank
An unusual natural structure in New Zealand may give clues to the formation processes of barrier islands. The Boulder Bank, at the entrance to Nelson Haven at the northern end of the South Island, is a unique 13 km-long stretch of rocky substrate a few metres in width. It is not strictly a barrier island, as it is linked to the mainland at one end. The Boulder Bank is composed of granodiorite from Mackay Bluff, which lies close to the point where the bank joins the mainland. It is still debated what process or processes have resulted in this odd structure, though longshore drift is the most accepted hypothesis. Studies have been conducted since 1892 to determine the speed of boulder movement. Rates of the top-course gravel movement have been estimated at 7.5 metres a year.[20]
Types
Richard Davis distinguishes two types of barrier islands, wave-dominated and mixed-energy.
Wave-dominated
Wave-dominated barrier islands are long, low, and narrow, and usually are bounded by unstable inlets at either end. The presence of longshore currents caused by waves approaching the island at an angle will carry sediment long, extending the island. Longshore currents, and the resultant extension, are usually in one direction, but in some circumstances the currents and extensions can occur towards both ends of the island (as occurs on Anclote Key, Three Rooker Bar, and Sand Key, on the Gulf Coast of Florida). Washover fans on the lagoon side of barriers, where storm surges have over-topped the island, are common, especially on younger barrier islands. Wave-dominated barriers are also susceptible to being breached by storms, creating new inlets. Such inlets may close as sediment is carried in them by longshore currents, but may become permanent if the tidal prism (volumn and force of tidal flow) is large enough. Older barrier islands that have accumulated dunes are less subject to washovers and opening of inlets. Wave-dominated islands require an abundant supply of sediment to grow and develop dunes. If a barrier island does not receive enough sediment to grow, repeated washovers from storms will migrate the island towards the mainland.[21]
Mixed-energy
Wave-dominated barrier islands may eventually develop into mixed-energy barrier islands. Mixed-energy barrier islands are molded by both wave energy and tidal flux. The flow of a tidal prism moves sand. Sand accumulates at both the inshore and off shore sides of an inlet, forming a flood delta or shoal on the bay or lagoon side of the inlet (from sand carried in on a flood tide), and an ebb delta or shoal on the open water side (from sand carried out by an ebb tide). Large tidal prisms tend to produce large ebb shoals, which may rise enough to be exposed at low tide. Ebb shoals refract waves approaching the inlet, locally reversing the longshore current moving sand along the coast. This can modify the ebb shoal into swash bars, which migrate into the end of the island up current from the inlet, adding to the barrier's width near the inlet (creating a "drumstick" barrier island). This process captures sand that is carried by the longshore current, preventing it from reaching the downcurrent side of the inlet, starving that island.[22]
Many of the Sea Islands in the U.S. state of Georgia are relatively wide compared to their shore-parallel length. Siesta Key, Florida has a characteristic drumstick shape, with a wide portion at the northern end near the mouth of Phillipi Creek.
Ecological importance
Barrier islands are critically important in mitigating ocean swells and other storm events for the water systems on the mainland side of the barrier island, as well as protecting the coastline. This effectively creates a unique environment of relatively low energy, brackish water. Multiple wetland systems such as lagoons, estuaries, and/or marshes can result from such conditions depending on the surroundings. They are typically rich habitats for a variety of flora and fauna. Without barrier islands, these wetlands could not exist; they would be destroyed by daily ocean waves and tides as well as ocean storm events. One of the most prominent examples is the Louisiana barrier islands.[23]
See also
- North Frisian Barrier Island
- Outer Banks
- Virginia Barrier Islands
- New York Barrier Islands
- Texas barrier islands
- Sea Islands
- Long Beach Island
- Bald Head Island
Notes
References
- ^ Garrison, J.R., Jr., Williams, J., Potter Miller, S., Weber, E.T., II, McMechan, G., and Zeng, X., 2010, "Ground-penetrating radar study of North Padre Island; Implications for barrier island interval architecture, model for growth of progradational microtidal barrier islands, and Gulf of Mexico sea-level cyclicity:" Journal of Sedimentary Research,' v. 80, p. 303–319.
- ISBN 978-1-4696-3250-6. Retrieved 2020-09-15.
- ^ a b Davis & FitzGerald (2004), p. 144.
- .
- ^ a b Smith, Q.H.T., Heap, A.D., and Nichol, S.L., 2010, "Origin and formation of an estuarine barrier island, Tapora Island, New Zealand:" Journal of Coastal Research, v. 26, p. 292–300.
- ^ a b Davis (2016), p. 8
- ISBN 0-8130-1496-4.
- ISBN 0-631-17306-4.
- S2CID 54010731.
- ^ Leatherman, S.P (1976). "Barrier island migration: an assessment of the overwash process". Geological Society of America Abstracts with Programs. 8: 215.
- ^ Rosati, J.D (2009). "Concepts for Functional Restoration of Barrier Islands" (Engineer research and development center vicksburg ms environmental lab).
{{cite journal}}
: Cite journal requires|journal=
(help) - ^ Rosati, J.D; Dean, R.G; Stone, G.W (2007). "Morphologic evolution of subsiding barrier island systems". Proceedings 30th International Coastal Engineering Conference, World Scientific Press, in Press.
- ^ a b Davis & FitzGerald (2004), p. 147
- ^ Boggs, S., Jr., 2012, Principles of Sedimentology and Stratigraphy: New Jersey, Pearson Education, Inc., 585 p.
- ^ Coastal Services Center, NOAA's Coastal Services Center Barrier Islands: Formation and Evolution Archived August 8, 2010, at the Wayback Machine. Accessed April 10, 2011.
- ^ Davis (2016), pp. 43–51, 53–54, 66–69
- ^ Davis & FitzGerald (2004), pp. 144–145
- ^ Davis & FitzGerald (2004), p. 145
- ^ Morton, p. 2
- S2CID 129743083.
- ^ Davis (2016), pp. 11–13, 23, 29
- ^ Davis (2016), pp. 13–16, 31
- ^ Stone, G.W., and McBride, R.A., 1998, "Louisiana barrier islands and their importance in wetland protection: forecasting shoreline change and subsequent response of wave climate:" Journal of Coastal Research, v. 14, p. 900–915.
Sources
- Davis, Richard A. Jr.; FitzGerald, Duncan M. (2004), Beaches and Coasts, United Kingdom: ISBN 978-0-632-04308-8
- Davis, Richard A. Jr. (2016). Barrier Islands of the Florida Gulf Coast Peninsula. Sarasota, Florida: ISBN 978-1-56164-8085.
- Morton, Robert A. (2007), Historical Changes in the Mississippi-Alabama Barrier Islands and the Roles of Extreme Storms, Sea level, and human activities (PDF), U. S. Geological Survey